New from Flute Master

Stop Block Enhancement

Flute Master has just released an enhancement to their stop blocks. The purpose of this new product is to overcome the necessity of holding the bottom aluminum bar in place while tightening the thumb screw.

The improvement is a plastic insert you cut to the width between the lathe ways, and fastened to the bottom bar. The bottom bar passes through an opening in the plastic insert and is held in place with a lock nut.

The plastic bar prevents the bottom bar from rotating as the stop block is put in place. The plastic bar is 2 3/8 inches long to fit the largest lathes, and should be shortened to fit a smaller lathe.

The difference in this stop block and the original is the blue insert shown in the photo. To convert your present stop blocks, insert the lower 3/4" x 1/4" aluminum bar through the insert and thread the all-thread bolt into the lock nut on the bottom. Use your same top 3/4" x 1/4" aluminum bar and thumb screw.

Tip: Cut the blue insert to fit snugly between the ways of your lathe bed. You may want to cut the length of the lower aluminum bar to fit between the brackets that fasten to the ways of the lathe bed.

Inserts can also be used on index wheel pin holders, and Spiral Master idler bases.

This improvement is not yet available on their web site. They are making a special offer at this time at 1/2 the expected list price.

To get your early 1/2 -price stop block enhancement, which includes a pair of inserts and lock nuts, send an e-mail order to

The cost is $5.00 per pair of inserts and lock nuts.

You can also order by mailing a $5.00 check to:

Dick Webber
6801 Broadway Ext.,
Suite 120
Oklahoma City, OK 73116

For more information or to order, click here


Click here to see all the New and Hot Items from 2016

Click here to see all the New and Hot Items from 2017

Previous "New and Hot" items:

Powered by Google

Great Bargains on Sale until July 5, 2018

Starter Pen Turning Kit

On Sale starting at $59.99 each

Save $10.00

List price normally starts at $69.99

All the essentials you need for pen turning, including 3 blanks, 3 hardware kits and a Pen Mill Kit with four pilot shaft sizes.

Click here for more information or to purchase

Pen-Turning Ergonomic Carbide Turning Tools, 3-Piece Set

On Sale for only $109.99 each

Save $30.00

List price: $139.99

Compact, comfortable rubber handles provide excellent control and reduce fatigue—replaceable carbide tips need no sharpening.

Click here for more information or to purchase

Customized Electric Branding Iron Gift Set

On Sale for only $99.99 each

Save $20.00 each

List price: $119.99

Personalized branding iron gift set lets your favorite woodworker customize their own design and message.

Click here for more information or to purchase

Excelsior Mini Lathe

On Sale for only $199.99 each

Save $100.00

List price: $299.99

With solid cast-iron construction, a robust 1/2 hp motor and a precision-machined live center, this little workhorse rivals features found in much larger lathes.

Click here for more information or to purchase

Powered by Google

Our Newsletter

We update our home page about monthly to feature a new project, a new article, and a new and hot tool. Then we create a newsletter to alert our subscribers.
We never let anyone use our list, and our subscribers have been wonderfully loyal as a result.

We hope you will try it out!

Sign Up For Our Newsletter

A Sampling of our Sponsors:
(Visit the Vendor's Corner above to see all our sponsors)

Woodturning with Tim

(Click any Ad to go to our Sponsor's Website)